A frayed or snapped lift cable throws the whole door off balance, and a door hanging crooked on one cable is a genuine safety hazard. We replace cables and inspect the drums they wind onto.
When one lift cable fails, the other has seen the same wear cycle. We replace both to prevent a repeat call.
Cable replacement without a drum check is an incomplete repair, so we always look at both.
Lift cables connect directly to spring-loaded drums, so replacement requires the same careful tension handling as spring work.
A same-day fix is standard for cable failures, parts already on the truck.
Whatever brought you here, one of these service lines is the fix, and one call gets a technician moving.
A snapped cable leaves the door hanging unevenly on the remaining side, an unsafe condition we treat as priority.
Catching a fraying cable early avoids the sudden, uneven drop that comes with a full snap.
A cable that's jumped its drum groove can jam the door mid-cycle. We reset it correctly and check for the underlying cause.
We match new drums to the correct diameter for your door's cable length requirements.
Correcting an uneven lean means addressing the cable, checking the spring pair, and confirming the track is still square.
A quick description of the lean or jam gets the right cable gauge loaded before arrival.
Technicians carry standard cable gauges and lengths for most residential doors.
We check both cables and the drums together, then quote a flat price covering the full fix.
Cables replaced, tension balanced, and the door tested level before we leave, backed by written warranty.
“Cable kept jumping the drum every few cycles. Turned out the drum itself was cracked, replaced and fixed.”
“Explained why replacing just one cable wasn't a real fix. Makes sense once you see the wear pattern.”
“Door was jamming mid-cycle for weeks. Cable and drum issue, fixed in one visit.”
This almost always means one lift cable or spring has failed while the other side is still holding weight.
Replacing just one often leads to a second failure soon after. We're upfront about that tradeoff.
We treat cable failures as priority calls given the safety risk involved.
Usually a bent or worn drum groove, sometimes combined with a slightly loose cable tension setting.
You'll get a confirmed price on-site once the technician inspects the full cable and drum setup.
A snapped-cable call usually resolves in under two hours on-site.
Licensed technicians, flat-rate pricing, and a truck stocked for this exact job.
☎ Call +1-831-293-1591From one side of Melrose Park to the other, dispatch is built to reach you quickly.
Embedded Map Placeholder for Melrose Park, IL